The R718PQA is a wireless communication device that detects toilet occupancy. The device is equipped with a reed switch sensor for detecting the switch status of the door; a built-in PIR sensor (pyroelectric human body infrared sensor) to detect whether someone is in the toilet. Two detections are established at the same time to determine if the toilet is occupied. Through the wireless network, the detected data is transmitted to other devices for display, which uses the SX1276 wireless communication module.

R718C series can be connected according to requirements: Type T thermocouple (R718CT) ; Type K thermocouple (R718CK), and it will display the collected data in the gateway

Broadband Quad MOSFET Eval. Board

Netvox Wireless IR Blaster can be used for IR learning and application. After IR learning, R211 can send the infrared control signal to corresponded electric devices. R211 can receive infrared signal from other infrared device and process predefined action, ex. controlling other LoRa devices.

Multi-interface Platform for Connecting Sensors

R831 is a device used to control the switch and is mainly used for the switch control of the strong electric motor control box.

Class D Full Bridge DVK

Half Bridge DVK

The R718WA2 Device is a LoRaWAN™ Device compatible with LoRaWAN™ Protocol (Class A). When the sensor detects the leak, it will send an alarm message to the gateway. R718WA2 carries 2 water leak sensors. It uses SX1276 wireless communication module.

The NETVOX R718N125 LoRaWAN wireless single-phase current detector is used to detect single-phase electrical input current.

High-Linearity MOSFET Quad Mixer Eval. Board

The R720A is a wireless communication device that detects ambient air temperature and humidity. The R720A detects the temperature and humidity of the air and transmits the detected data to other devices via a wireless network using the SX1276 wireless communication module.

The Netvox R718G LoRaWAN device has a built-in light sensor that can be used for ambient light intensity detection. It uses the SX1276 LoRaWAN wireless communication module. The R718G detects the ambient light intensity value and adds it to the gateway. The collected data is displayed in other devices.

MILESIGHT UC502 LORAWAN CONTROLLER WITH BUILT-IN 190000MAH REPLACEABLE LI-SOCL2 BATTERY

Eval board for Ag5800 PD Module,
IEEE802.3bt POE

Solar Battery Charger Eval Board

Eval board for Ag6800 PSE Module,
IEEE802.3bt POE

The Netvox R718N17 LoRaWAN wireless single-phase current detector is used to detect 1-phase electrical input current.

The LIG16 is an open source LoRaWAN Indoor Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet network. The LoRa wireless allows users to send data and reach extremely long ranges at low data-rates.